Zenoss snmp trap receiver
- Zenoss snmp trap receiver how to#
- Zenoss snmp trap receiver serial#
- Zenoss snmp trap receiver software#
Issue the no snmp-server host informs command to disable informs. The no snmp-server host command with no keywords disables traps, but not informs, to the host. If no version keyword is present, the default is version 1. If you enter this command with no keywords, the default is to send all trap types to the host. The snmp-server host command is disabled by default. xgcp-Sends External Media Gateway Control Protocol (XGCP) notifications.tty-Sends Cisco enterprise-specific notifications when a Transmission Control Protocol (TCP) connection closes.Specify the level of messages to be sent with the logging history level command. syslog-Sends error message notifications (Cisco Syslog MIB).
Zenoss snmp trap receiver serial#
Zenoss snmp trap receiver software#
There are two global configuration commands that you use to configure SNMP traps into a Cisco IOS Software device: Cisco IOS Software defines groups of traps that you can enable or disable. For instance, if you enable all traps in a Remote Access Server with 64 dial-in lines, you get a trap whenever a user dials in and whenever a user terminates the connection.
Zenoss snmp trap receiver how to#
You do not want a Cisco device to send all of the SNMP traps that the device knows how to send. Readers of this document must understand this information: You can find a current list of all supported Cisco IOS Software Simple Network Management Protocol (SNMP) trap Object Identifiers (OIDs) in this document.Ĭisco devices that run the standard IOS Software (routers, Asynchronous Transfer Mode (ATM) switches and Remote Access Servers) of Cisco can generate many SNMP traps. When you use a Cisco IOS Software release later than 12.1(3)T, additional options can be supported. When you use an earlier Cisco IOS Software Release, not all options are supported.
Note: Cisco IOS Software Release ® 12.1(3)T was used to prepare this document.